Teracue DCH-510P, Руководство пользователя

Страница: 24 / 30

DCH-510P™
User Guide V1.1
24
7.2 How to set the Unicast/Multicast output
If the IP hardware board is configured as IP Input, please follow below procedure to change it to IP
output:
1. Only on the front panel is accessible, go to
Main Menu -> System -> Optional function -> External board type -> IP Out
2. Switch off the unit, and then switch it on again. Then the unit will become IP Out, and the
FACTORY DEFAULT setting will not change this IP direction. And at the same time, the menu
structure on front panel & HDMS (the PC management software) will be changed accordingly.
To set Unicast/Multicast output, please follow the procedure below:
1. Go to the Main menu -> Output -> Ethernet
2. Set the IP address & parameters for the IP hardware board: Stream IP
address -> enter the IP address for this IP hardware board (should be the same network
section of the Stream Gateway, this depends on the characteristic of the gateway)
Stream Netmask -> enter the network submask for this IP hardware board
Stream Gateway -> enter the Gateway address for this IP hardware board
Stream MAC address -> Show the MAC address of this IP hardware board, read only.
3. Set the universal parameters for the output IP stream. On the same sub menu:
Gate MAC address -> here the MAC address must be set as the MAC address of the Gateway
where DCH-510P™ is located.
Protocol -> enter the protocol of the output stream, DCH-510P™ supports UDP and RTP.
TS Pkts per UDP -> set the quantity of TS packages that will be carried IP package. The
range goes from 1 ~ 7
Time to Live -> set the TTL for the output IP package.
Type of Service -> set the type of service for the output IP stream
Source -> set the wanted stream output via IP.
Mode -> Set the IP output mode as IPTV mode or DVB mode.
4. If the mode is set to be DVB mode, please follow below procedure ‘DVB mode’. If the mode is
set to be IPTV mode, please go to procedure ‘IPTV mode’ directly.
DVB mode:
Unicast/Multicast Setup -> set the address and port parameters for the IP stream. Press Enter to go to
the submenu. As below:
Multicast IP -> enter the multicast IP address for the output stream.
Multicast UDP Port -> enter the port number of the output stream.
Target Mac address-> set the MAC address of the receiving device. The parameter will be
used only when the receiving device is located under the same gateway. The parameter will
be ignored by DCH-510P™ if the receiving device is located under other remote network or
under different gateway.