Teracue DCH-510P, Руководство пользователя

Страница: 23 / 30

DCH-510P™
User Guide V1.1
23
7. IPTV Configuration Quick Guide
First of all, make sure that your unit is equipped with IP hardware board. If not, please contact your
agent for information.
7.1 How to Receive a Multicast or Unicast Stream
Normally, the DCH-510P™ is set to IP Output by the factory. To set the DCH-510P™ to IP input
mode, please follow the procedure below:
1. Only on the front panel is accessible, go to
Main Menu -> System -> Optional function -> External board type -> IP in
2. Switch off the unit, and then switch it on again. Then the unit will become IP in, and the
FACTORY DEFAULT setting will not change this IP direction. And at the same time, the menu
structure on front panel & HDMS (the PC management software) will be changed accordingly.
To receive a multicast/unicast stream:
1. Go to the Main menu -> Input -> Ethernet
2. Set the IP address & parameters for the IP hardware board,
Stream IP address -> enter the IP address for this IP hardware board (should be the same
network section of the Stream Gateway, this depends on the characteristic of the gateway)
Stream Netmask -> enter the network submask for this IP hardware board
Stream Gateway -> enter the Gateway address for this IP hardware board
Stream MAC addr -> Show the MAC address of this IP hardware board, read only.
3. Set the parameters for the incoming IP stream. On the same sub menu:
Multicast IP address -> enter the multicast IP address for the incoming stream
Multicast UDP port -> enter the port number of the incoming stream
Protocol -> enter the protocol of the incoming stream, DCH-510P™ supports UDP and RTP.
Output Smoothing -> Clock recover method from IP incoming stream, MUST set to Auto (both
Auto & Fixed rate are for experimental test only).
TS Bit Rate -> set to the bit rate of incoming stream in experimental test, this value will be
ignored by DCH-510P™ if “Output Smoothing = Auto” in previous step.
4. After previous steps, DCH-510P™ will capture the incoming IP stream immediately. Normally
it takes 30-60 seconds to lock the stream. You can go to the Main menu -> inputs -> Status->
IP IN to check the bit rate of incoming stream.
5. Finally, if user wants to watch TV decoded from IP incoming stream on the output of DCH-
510P™, don’t forget to set the decoder portion of DCH-510P™ to select IP as the program
source.