Teracue DCH-510P, Руководство пользователя

Страница: 11 / 30

DCH-510P™
User Guide V1.1
11
5.1.4 Ethernet Menu
(The Ethernet menu is showed only if the IP streaming in/out board is installed and the TS/IP
streaming board is set to “IP IN”. Refer to chapter 5.3.6.)
The Ethernet connector is for receiving transport stream over IP. The Ethernet connector has user-
configurable IP address, network mask and default gateway. These must be set to appropriate values
for the network over which the transport stream over IP is received.
Stream IP Addr: Enter the IP address for streaming IP input of the unit.
Stream Netmask:
Enter the network sub mask for the subnet to which the unit is connected
for IP streaming traffic.
Stream Gateway:
Set the gateway for the network to which the unit is connected for IP
streaming traffic.
Stream Mac Address: factory-set MAC addresses are guaranteed to be unique. Therefore
you can not configure the address.
Multicast IP Addr:
Enter the IP address of the multicast stream for the transport stream over
IP.
Multicast UDP Port:
Enter the UDP port number of the TS over IP stream.
Protocol: select the protocol for multicast: UDP or RTP.
Output Smoothing: set the quality of TS which comes from the TS/IP input.
Auto: The bit rate is variable.
Disable: The unit let the TS pass by.
Fixed Rate: The bit rate is fixed.
TS Bit Rate:
set the bit rate of the TS from the TS/IP input. The setting is only valid when the
output smoothing is configured as Fixed Rate.
5.2 Output Menu
Under Output Menu, you can monitor and configure the parameters of the CI, AV decoder, ASI out,
ASI2/SDI out, MUX (A), BISS, SDI out and TS over IP output (B).
Note: (A)The MUX menu is showed only if the built-in MUX portion is enabled. Refer to chapter
5.3.6.
(B) The Ethernet menu is showed only if the IP streaming in/out board is installed and the
TS/IP streaming board is set to “IP Out”. Refer to chapter 5.3.6.
Outputs
BISS CI Decoder ASI1 ASI2 Ethernet Mux
SDI