MAINTENANCE
57
S20 Gas/LP 9006719 (8
−
2009)
4. Turn the bypass valve 90
_
from the normal
position before winching the machine onto the
truck or trailer. See
PUSHING OR TOWING
THE MACHINE
section of this manual. Make
sure the machine is centered.
FOR SAFETY: When loading machine onto
truck or trailer, use winch. Do not drive the
machine onto the truck or trailer unless the
loading surface is horizontal AND is 380 mm
(15 in) or less from the ground.
5. Position the machine onto the truck or trailer
as far as possible. If the machine starts to
veer off the center line of the truck or trailer,
stop and turn the steering wheel to center the
machine.
6. Set the parking brake and block the machine
tires. Tie down the machine to the truck or
trailer before transporting.
The front tie-down locations are the holes in
the wheel pockets at the front of the machine
frame.
The rear tie-down locations are the holes in
the sides of the machine frame near the rear
bumper.
7. If the loading surface is not horizontal or is
higher than 380 mm (15 in) from the ground,
use a winch to unload machine.
If the loading surface is horizontal AND is 380
mm (15 in) or less from the ground, the
machine may be driven off the truck or trailer.
FOR SAFETY: When loading machine onto
truck or trailer, use winch. Do not drive the
machine onto the truck or trailer unless the
loading surface is horizontal AND is 380 mm
(15 in) or less from the ground.
8. Return the bypass valve to the normal
position when through loading the machine
.
Refer to
PUSHING OR TOWING THE
MACHINE
section of this manual.
