MAINTENANCE
52
S20 Gas/LP 9006719 (4
−
2014)
SKIRTS, FLAPS, AND SEALS
FOR SAFETY: Before leaving or servicing
machine, stop on level surface, set parking
brake, turn off machine, and remove key.
HOPPER LIP SKIRT
The hopper lip skirt is located on the bottom rear
of the hopper. The skirt floats over debris and
helps deflect that debris into the hopper.
Check the hopper lip skirt for wear or damage
daily.
Replace the hopper lip skirt when it no longer
touches the floor.
HOPPER SIDE SKIRT
The hopper side skirt is located on the left side of
the hopper. The hopper side skirt should clear the
floor by 3 mm (0.12 in).
Check the hopper side skirt for wear or damage
and adjustment daily.
BRUSH DOOR SKIRTS
The brush door skirts are located on the bottom of
each of the two main brush doors. The skirt
should clear the floor by 3 mm (0.12 in).
Check the skirts for wear or damage and
adjustment daily.
NOTE: The brush door skirts have slotted holes
to allow for a ground clearance adjustment. Adjust
the skirt height with the door closed.
NOTE: Rear tire pressure will affect skirt
clearances.
REAR SKIRTS
The two rear skirts are located on the bottom rear
of the main brush compartment. The vertical skirt
should clear the floor up to 3 mm (0.12 in). The
recirculation skirt requires no adjustment.
Check the skirts for wear or damage and
adjustment daily.
NOTE: Rear tire pressure will affect skirt
clearances.
