Blizzard G4 User Manual
10
Mounting Bolts
Each Enclosure must be mounted with FOUR points.
All mountings must be made using the four M10
threaded holes on the top or bottom of the
enclosure.
Use a 6mm hex key to secure the M10 socket cap
screws provided.
Tempest Lighting recommends the use of stainless
steel mounting hardware.
Make sure the inlet filter has at least 75mm/3in
clearance below.
IMPORTANT SAFETY NOTICES
Installer must ensure that all mounting points are secure
and conform to local safety regulations. Tempest Lighting
Inc. accepts no responsibility for damage or injury arising
from inappropriate or unsafe installation.
Check that the tip of each mounting bolt is clearly visible
below the nut welded to the internal mounting plates. If
the bolt thread is not visible, remove and replace with a
longer bolt.
6mm
Important:
Sealing Washers –
install with rubber side
to enclosure surface
Stainless Steel
Neoprene Rubber
