Blizzard G4 User Manual
11
Mounting Options – Stacking Kit
Blizzard G4 may be stacked up to four units high, using
the 52.SK stacking Kit. You will need the total number of
Blizzards to be stacked, minus one stacking kit(s).
Note: Blizzards must be of the same model to stack in this
way.
52.SK
Stacking Kit (set of four, for one enclosure)
Mounting Options – Unistrut Kit
If mounting positions for the corner bolts are not
convenient, use the Unistrut Kit (52.UR.050/100/150) to
add two Unistrut rails and Unistrut spring nuts.
Using the spring nuts, the enclosure may now be
attached at any point along the Unistrut rails.
Note that the Unistrut Rail kit is required for use of
Blizzard enclosures with the Cyclovator tilt kit.
Mounting Options – Cyclovator
Cyclovator allows you to mount up to two Blizzard 100 or
150 enclosures and tilt them up to 60 degrees either up
(mapping up onto a building or down from a rooftop).
When enclosures are tilted more than about 30 degrees
up or down, use an inlet filter cowl to protect the filter
from rainfall.
55.C2
Cyclovator
52.UR.xxx Unistrut Rail Kit (required)
52.SK
Blizzard Stacking Kit (only required to stack two
Blizzards)
52.IC.xx Inlet Cowl
Note that the Unistrut Rail kit is required for use of
Blizzard enclosures with the Cyclovator tilt kit.
Unistrut Rails may be
mounted above or
below
Join top and bottom sections
together with Clevis pins
Bolt bottom leg
to M10 socket
each corner
Bolt top leg to M10
socket each corner
