Blizzard G4 User Manual
21
Ceiling-Style Orientation
To mount the projector ceiling style, you will need to re-
install the projector mounts so that they are attached to
the top of the enclosure instead of the base.
Illustrations here are for fixed projector mount, but the
procedure is the same for fixed or slide mounting
Blizzards.
1.
Remove both projector bails and all four
projector rods
2.
Remove the eight M10 rigging bolts from
the top and bottom corners of the
enclosure, using a 6mm hex key
3.
Remove the four rigging plates under the
top cover by removing the M4 nut, using a
7mm nut driver
4.
Remove the six M4 nuts attaching each of
the projector beams to the enclosure base,
using a 7mm nut driver
5.
Lift the projector beams and bridges out of
the enclosure base, invert them, and
replace under the top cover. Secure using
the 12 M4 nuts you removed from the
base.
6.
Replace the four rigging plates in the
bottom of the enclosure, using the M4
nuts you removed from the top.
7.
Replace the eight M10 rigging bolts.
8.
Replace the projector rods and bails.
Fixed projector mounts in ceiling mode
M10 Rigging Bolts
M4 Nuts
Section view of
enclosure base
Projector Rods and
Bails – remove
Section view under
enclosure cover
Rigging Plate
M10 Rigging Bolt
Studs for Projector
Beam in ceiling
mode
