Blizzard G4 User Manual
22
Mount the Projector – Fixed Mount
Fine for most applications, fixed
mounts hold the projector firmly in
place, while allowing access from
either side and from the back for
alignment, service and lamp changes.
Tabletop Installation
1.
Loosen the Bridge Clamp Screws both
sides
2.
Slide the projector bridges to align with
projector feet, and re-tighten the bridge
clamp screws.
3.
Remove the projector rods nearest you, by
loosening the rod nuts and unscrewing
from the projector bridges.
4.
Slide the projector along the projector
bridges so that it is roughly centered in the
enclosure
5.
Replace the projector rods nearest you.
6.
Align the projector, using the projector
feet to adjust tilt and roll.
7.
When projector alignment is complete,
lower the projector bails and secure firmly
in place by tightening projector rod nuts.
Projector Bails
Projector Beam
Projector Bridge
Projector Rod
Bridge Clamp Screws
Mount the Projector – Slide Mounts
(1)
Slide Mount: slide out the projector tray and
set the projector in place
(2)
Adjust the projector bails for a loose fit (you
will adjust and lock down later)
Projector
Bails
