SE867-AGPS User Guide
1VV0300860 Rev. 3 - 2010-05-10
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 53 of 69
Name
For
mat
Valid values
Default
value
Description
X
N/A
N/A
N/A
N/A
AntennaDelay
Decimal
Number
-500…500
0
Antenna cable delay configuration (in
nanoseconds)
X
N/A
N/A
N/A
N/A
The antenna delay can be changed by the following command
T,
Delay
*cc
Delay
*cc
$PUNV,CONFIG,AN
or
$PUNV,SET,ANT,
Name
Format
Valid values
Default
value
Description
Delay
Decimal
Number
-500…500
0
Antenna cable delay configuration (in
nanoseconds). Typical cable types such as
RF58, RG174 and RG214 cause a delay of
5ns per meter, i.e. the signal propagates in
them 20cm in one nanosecond.
In case of successful execution of
in the following form:
of execution of GETCONFIG, CONFIG or SET command the receiver
ply message. Please see the ERR section for details (10.1.2.17).
10.1.3.8.
Datum Configuration
The Datum configuration is used to select the output datum.
The current configuration can be read in the system by the following command:
$PUNV,GETCONFIG,13*43
The answer is as follows:
$PUNV,CONFIG,ANT,
Delay
*cc
command, the receiver sends the confirmation
$PUNV,CFG_S,11*5A
In case of a failure
sends the ERR re
