TELink
1200
7 Rev.
4/25/01
INSTALLATION PROCEDURE B
(Dedicated Line)
1. Make sure the power switch on the back of the TELink is OFF.
2. Connect one end of the included modular telephone cable directly to the phone company box for
the installation phone number. It is important that this cable is attached to a direct line, prior to any
other telephone equipment. The user may need to adapt one end of the modular cable to mate to
the incoming phone line.
3. Connect the other end of the modular cable to the TELCO jack on the back of the TELink.
4. Set the HI/LO switch on the back of the TELink to the proper position for the sound system (LO=8
Ohm, HI=600 Ohm).
5. Connect the TELink's AUDIO OUTPUT jack to the sound system using the included RCA cable.
The user may need to adapt the sound system end of this cable to match the sound system's input
jack.
6. Connect your BGM source to the TELink's BGM INPUT jack. Make sure the BGM source is on,
set up properly and providing audio output.
7. Plug the included 12VDC power supply into a 110VAC wall outlet. Connect the other end to the
12VDC jack on the back of the TELink.
8. Turn the power switch ON. Turn to page 9 for further instructions.
TELink 1200
