6 Introduction
C-2000 and C-2000HS Technical Manual
Bosch Security Systems, Inc.
Technical Manual
F.01U.174.927 Rev 03
Features
C-2000HS Features
The C-2000HS is shipped from the factory in the following state:
•
4-wire mode
•
Full-duplex
•
TX monitor enabled
•
F3–F16 disabled
•
600 Ohm TX output impedance
•
600 Ohm RX input impedance
C-2000 Features
The C-2000 is shipped from the factory in the following state:
•
4-wire mode
•
Full-duplex
•
TX monitor enabled
•
F3–F16 Disabled
•
600 Ohm TX output impedance
•
600 Ohm RX input impedance
•
Handset disabled
•
Desk microphone enabled.
Display Character Description
CC
(Clone Complete) -
Cloning is successful.
CL
(Clone Mode)
-
Clone mode is entered.
CD
(Crossmute) -
Another parallel console is active and pull crossmute low.
CP
(Correct PIN) -
The PIN number is correctly entered.
EE
(Error) -
An error occurred, seen in clone mode if cloning fails.
EP
(Enter Pin) -
A PIN number needs to be entered to access setup mode.
FD
(Function Duration) - Function duration programming mode is entered.
FF
(Function Frequency) - Function frequency programming mode is entered.
IP
(Incorrect PIN) -
An incorrect PIN number was entered.
OC
(Option Changed) -
The option selected is changed.
PC
(PIN Changed) -
The PIN was successfully changed.
SS
(Settings Saved)
-
The current settings are permanently saved.
SU
(Supervisor) -
The supervisor pin is activated by a parallel console.
