C-2000 and C-2000HS Technical Manual
Setup 33
Bosch Security Systems, Inc.
Technical Manual
F.01U.174.927 Rev 03
Clone Mode Overview
ENTER(#) key:
Used to enter Clone Mode.
ESCAPE(*) key:
Used to exit Clone Mode.
DTMF B:
Sets up the slave/receive mode. Must be done prior to receiving data.
DTMF A:
Starts data transmission from the master. Slave will indicate Clone Complete.
Setup State 30
Full Duplex Mode Enable/Disable
The
Full-Duplex Mode Enable/Disable
is used to set whether the C-2000 has the full-duplex mode of operation enabled or
disabled. Full-Duplex allows the operator to listen to incoming traffic during a PTT sequence.
Setup State option:
1=Enable*
2=Disable
To
enable/disable full duplex mode,
do the following:
1.
Select the
setup option
using FUP/FDWN keys.
2.
Press
Enter (#).
Display shows OC (Option Changed)
.
Setup State 31 Handset Enable/Disable
The
Handset Enable/Disable
is used to set whether the C-2000 has the handset enabled or disabled. This is used to determine
the routing of receive audio.
Setup State option:
1=Enable*
2=Disable
To
enable/disable the handset,
do the following:
1.
Select the
setup option
using FUP/FDWN keys.
2.
Press
Enter (#).
Display shows OC (Option Changed)
.
