Telenetics Corporation FT100 S, Инструкция по установке и эксплуатации

Страница: 104 / 134

Control Port Operation
6-26 FT 100S
Remote Configuration Mode CRM
The choice for this option determines which FT 100S or FT 100 may
actually handle all of the configuration for both units. The FT 100S or
FT 100 that is selected for slave mode may be configured from the
master unit and request the configuration from the master unit but may
not change it.
Get Remote Configuration CR1
This command initiates the actual downloading of the remote FT 100S
or FT 100's configuration information. Once this is complete, the option
and summary screens for the remote unit may be viewed by selecting
the configuration control on the local unit for remote configuration.
Send Remote Configuration CR2
This command initiates actual transmission of the configuration infor-
mation across the data link to the remote FT 100S or FT 100.
☞
Note
The remote FT 100S or FT 100's configuration is not actu-
ally updated until this command is successfully executed.
When changes are made to the various configuration options for the
remote FT 100S or FT 100, they are stored in the local FT 100S. There-
fore, that information must be sent across the network using this
command before the remote unit reflects any of the changes made.
Send Remote Unit ID CR3
Sends the remote units ID across the data link after being determined
and entered at the local unit.
Send Remote Password CR4
Sends the remote units password across the data link after being deter-
mined and entered at the local unit.
Send Remote Time and Date CR5
Sends the remote units time and date across the data link after being
determined and entered at the local unit.