Telenetics Corporation FT100 S, Инструкция по установке и эксплуатации

Страница: 101 / 134

Control Port Operation
FT 100S 6-23
SF Error
When SF framing is selected, the two error history reporting registers
are the same as in AT&T 54016. The only difference is that the carrier
cannot read the carrier registers since there is no FDL.
Local Error History ANSI T1.403
The local performance history allows display of error history data accu-
mulated by the local FT 100S when ANSI T1.403 ESF mode is selected.
The Local 1-Hour Performance Data screen displays a summary of error
history accumulated during the previous hour. Also displayed are the
24-hour totals for each error count.
The Local 24-Hour Performance Data screen displays all accumulated
15-minute intervals during the previous 24 hours.
Remote Error History Per AT&T 54016
When in the AT&T 54016 ESF mode, remote error history is available
over the ESF data link as defined by AT&T Technical Reference 54016.
The desired remote error history information may be requested by
entering the appropriate selection preceded by an 'R' (see below). If the
request is successful, the proper report is displayed. If the request is
unsuccessful, the status line indicates an ESF data link communications
error.
The Remote ESF Performance Data report shows ESF errors counted at
the remote FT 100S and the status of the Payload Loopback.
The Remote 1-Hour Performance Data report displays the ES, UAS,
BES, SES, CSS and LOFC performance data gathered at the remote FT
100S for the last hour period (the data is stored in 15- minute intervals).
The Remote 24-Hour Performance Data reports display their respective
error event performance data gathered at the remote FT 100S for the last
24-hour period (the data is stored in 15-minute intervals).