Teledyne CombiFlash EZ Prep, Руководство пользователя

Страница: 19 / 245

Section 1 Introduction
1-11
Table 1-2 Combi Flash Rf
+
Lumen
Specifications
1
Dimensions 61 cm (24")

36 cm (14.1")

43 cm (17") (H

W

D)
Weight 30.75 kg (67.8 lbs)
Power Options
Input voltage range from 100 to 240 VAC, 50/60 Hz,
2.0 Amps system maximum.
Line cord is the disconnect device.
Line Frequency 50/60 Hz
Ambient Temperature 20 to 40 °C (maximum temperature must be at least
15 °C below the boiling point of the solvent)
Humidity (when
connected to power) 0 to 95% non-condensing
Flow Rate Range 1 to 200 mL/min
Flow Rate Accuracy ±5% (5-200 mL/min)
Pressure Limit
2
1379 kPa (200 psi)
Pressure Accuracy 5% of full scale
Gradient Formation Binary gradient from solvent inlets 1-4. Solvent
selection can be automatically controlled by the
method.
Peak Detection Modes Slope or threshold
Flow Cell Path Length 0.1 mm, ±25%
UV Detection and
Monitor Wavelength Selectable from 200 to 400 nm range. Optional 200 to
800 nm UV-Vis detector.
Wavelength Accuracy ±5 nm
Gas Inlet Pressure 60 to 70 psig
Gas Consumption <2.5 SLPM
Spray Chamber
Temperature Setting range: 10 to 60 °C
limited to minimum of 5 °C below ambient
Drift Tube Temperature Setting range: 30 to 90 °C
Must be 5 °C above spray chamber temperature
Minimum temperature is 5 °C above ambient
Maximum temperature is 60 °C above ambient