Teledata s.r.l. ONEMINI, Руководство пользователя и инструкция по установке

Страница: 14 / 88

ONEMINI
F
IRE
A
LARM
C
ONTROL
P
ANEL
U
SER AND
I
NSTALLATION
M
ANUAL
- R
EV
. 1.0.3 / 2018
P
AGE
12
5. Introduction to ONEMINI
5.1 General features
ONEMINI is a microprocessor-programmable fire detection control panel. This control panel
uses an analogue addressed system and an autonomous management of indications and
warning procedures.
The control panel is able to manage the fire detection through 1 analogue addressed lines.
The loop can control up to 240 detectors and IN/OUT modules.(120 devices for S Light
version)
The system is provided with a 32-bit microprocessor with RAM, flash memory and EEPROM
memory for the non-volatile storage of the configuration data.
The control panel can be programmed using the touch screen or by importing programming
data from a USB key.
Like all Teledata products, ONEMINI can be managed through the integrated supervisory
and control software.
5.2 Installation precautions
The electronic boards are provided with semiconductors that are sensitive to electrostatic
charges. For this reason the boards should be handled by their edges and their electronic
components should not be touched.
Carry out a good grounding in order to reduce the damageability and noise sensibility.
During the phase of designing the system, required autonomy should be taken into
consideration in order to scale the batteries to be utilized.
Disconnect the batteries, the AC power and any power supply before inserting or removing
an electronic board and before carrying out any maintenance work on the control panel
(except for the loading of a new FW version).
Peripheral devices like detectors, modules, sounders etc. that are not compatible with the
control panel can cause an improper operation of the control panel or even damage it.
It is therefore necessary to use materials compatible with the Teledata control panels.
ONEMINI control panel must be used with n°2 12V - 7.2Ah batteries