© Telect, Inc., All Rights Reserved, 12.7.16 v.4
1.509.926.6000 :: telect.com
47
User Manual
Advanced Distribution Frame (ADF) Systems
5.2 Network Cabling to Network Element Module
To connect network element cabling to a NE module, proceed as follows:
1. Remove the outboard raceway cover (two screws).
Telect, Inc. • USA +1.509.926.6000 • 52.33.3836.37.52
www.telect.com • © 2010 Telect, Inc., All Rights Reserved, 119736-4
Page 5-47
5.2 Network Cabling to Network Element Module
To connect network element cabling to a NE module, proceed as follows:
1. Remove the outboard raceway cover (two screws).
Outboard-Cabling Access Cover
Lift latch and swing inward
several or all trays above
Open outboard-cabling
access cover by sliding
finger tab toward aisle.
Slots for Inserting Cables
the 1st tray to be cabled.
Keep the 1st tray for cabling
latched in its closed position.
Cover Over Channels
of Outboard Raceway
Figure 43 - Network Element Cabling (Example)
2. As an aid in cabling the first tray, open several or all trays above the first tray. (To open trays,
pull slightly on the tray latches and then rotate the trays toward the inboard area of the ADF,
as shown in Figure 44, on the following page.)
3. For the first tray, open the outboard-cabling access cover by sliding the finger tab toward the
front aisle.
Figure 43 - Network Element Cabling (Example)
2.
As an aid in cabling the first tray, open several or all trays above the first tray. (To open trays, pull slightly on
the tray latches and then rotate the trays toward the inboard area of the ADF, as shown in Figure 44, on the
following page.)
3.
For the first tray, open the outboard-cabling access cover by sliding the finger tab toward the front aisle.
