TelcoBridges TSBC Series, Инструкции по установке

Страница: 24 / 52

TSBC Series System Installation Guide
18
3.3 Connecting to the Data Network
The TSBC-HW-SRV-HIGH and TSBC-HW-SRV-MID feature dual GigE ports for connection to multiple
VoIP networks. Both server models feature dual 1Gb and 10 Gb ports.
The data Ethernet ports can be used for either WAN or LAN networks or for the transcoding network.
Your network design will dictate which Ethernet ports are needed. For more information about the
TSBC data networks, refer to
https://docs.telcobridges.com/tbwiki/TSBC-SW:Networking
The IP address of the VoIP ports are configured using the Web Portal.
Note
If you do not have any transcoding units, connect the TSBC-HW-SRV units back to back.
Connection to the data network will vary based upon your server model and port configurations. The
following configurations are described:
• TSBC-HW-SRV-HIGH: 1Gb
• TSBC-HW-SRV-HIGH: 10Gb
• TSBC-HW-SRV-MID: 1Gb
• TSBC-HW-SRV-MID: 10Gb
3.3.1 TSBC-HW-SRV-HIGH: 1Gb
Prerequisites
To connect the TSBC-HW-SRV-HIGH to the data network using a 1Gb connection, you will need:
• Gigabit layer 2 Ethernet switch. A second one is required to support redundancy of the VoIP
interface.
• CAT5 Ethernet cables with RJ45 male-male terminations for connection to the 1Gb ports.
Connections
The TSBC-HW-SRV-HIGH is connected to the data network by one or optionally two 1Gb Ethernet
network links.
• To connect the TSBC-HW-SRV-HIGH to the data network, refer to Figure 3.3 on page 19.