TelcoBridges TSBC Series, Инструкции по установке

Страница: 12 / 52

TSBC Series System Installation Guide
6
• Height x Width x Depth (inch) 1.68 x 18.98" x 29.72"
The dimension of the TSBC-HW-SRV-MID (without bezel and redundant power supply)
• Height x Width x Depth (mm) 42.8 x 434.0 x 625.0
• Height x Width x Depth (inch) 1.68 x 17.08" x 24.60"
Adequate power supply and power connections
Each TSBC-HW-SRV requires two power connections to provide for its redundant power supply. To
guarantee an uninterrupted supply of electricity, each power connection must be fed by a dedicated
power source.
An IP address for the management port
Each TSBC-HW-SRV requires a IP address for the management port. To avoid delays, you should have
the IP address, netmask and gateway addresses on hand. Take note that the management port
supports DHCP, see
Section 3.1 “Connecting to the TSBC-HW-SRV Management Interface” on
page 16 for further information.
Cabling
Ensure that you have the correct quantity of cables for your system:
TSBC-HW-SRV-HIGH
• Fiber cable pairs (for 10G configurations)
• Ethernet CAT5 cables
TSBC-HW-SRV-MID
• Ethernet CAT5 cables
• Ethernet CAT7 cables (for 10G configurations)
1.2.2 TSBC-HW-TRANS
Adequate space for the installation of the TSBC-HW-TRANS
You will need to mount the TSBC-HW-TRANS on a 19" equipment rack (customer provided). The
TSBC-HW-TRANS is housed in a 1U chassis.
The dimension of the TSBC-HW-TRANS are:
• Height x Width x Depth (mm) 44.5 x 429.0 x 406.0
• Height x Width x Depth (inch) 1.75 x 16.9" x 16"
Adequate power supply and power connections
Each TSBC-HW-TRANS requires two power connections to provide for its redundant power supply.