TelcoBridges TSBC Series, Инструкции по установке

Страница: 18 / 52

TSBC Series System Installation Guide
12
2.2 Rack Mounting the TSBC-HW Equipment
The TSBC-HW equipment is mounted on a customer provided equipment rack using the mounting
hardware packaged in each box.
2.2.1 Prerequisites
To rack mount the equipment, you will need:
• One customer-provided equipment rack, measuring 19” in width and 29.7” in depth. The rack must
be solidly anchored to the floor with appropriate support at the top of the racks.
• Climate controlled room: 0 to +50 Celsius, 0 to 95% non-condensing humidity.
2.2.2 Vertical Placement of
the
Equipment
The TSBC-HW-SRV and TSBC-HW-TRANS are each housed in 1U chassis, as tabulated in table 2.1
on page 12. It is important that you provide for enough room on the equipment rack to allow for the
installation of the equipment.
Consider the available space on your equipment rack and the height of each piece of equipment.
Due to the rear-exhaust heat vents and the efficient heat dissipation design, there is no need to leave
any physical vertical space above or below the TSBC-HW-SRV or TSBC-HW-TRANS.
Table 2.1 TSBC-HW Physical Height
TSBC-HW Model Number Vertical Height
TSBC-HW-SRV-HIGH 1U (1.68 inches or 42.80 mm)
TSBC-HW-SRV-MID 1U (1.68 inches or 42.80 mm)
TSBC-HW-TRANS 1U (1.75 inches or 44.45 mm)