Tektronix HDVG1, Руководство по обслуживанию

Страница: 33 / 106

Installation
HDVG1 HDTV Digital Video Generator Service Manual
2- 9
9. Touch Select Destination . If desired, create a new directory for the logos by
selecting
New Dir
and entering a DOS compatible name.
10. Create a new file by touching New File . (The original logo name is
preserved inside the logo file.)
11.
Touch
Quit/Save
to begin the save process.
12.
Repeat for each logo you want to save.
To remove the module, follow these steps:
1. Turn off the platform by pressing the front-panel On/Standby switch and
switching the rear panel power switch to off.
2.
Unplug the power cord.
WARNING.
To avoid a shock hazard always unplug the power cord before
removing the top cover. Failure to unplug the power cord can result in serious
injury or death.
3. Remove all top-cover screws and remove the top cover. See Figure 2--2 on
page 2--3.
4. Remove the appropriate rear panel as shown in Figure 2--3 on page 2--4.
Loosen, but do not remove the bottom screw. You will use it later to secure
the rear panel.
5. Refer to Figure 2--6 on page 2--6 and remove the top screw.
6. Remove the module. To leave the slot empty, proceed to step 8 of this
procedure.
7. To install a module in the empty slot, proceed to Module Installation on
page 2--2.
8.
To ensure proper cooling and adherence to EMI shielding requirements,
install a blank panel to cover any empty slots in the rear panel. A spare blank
panel is included in the TG2000 Platform mainframe accessories kit.
9. Tighten the screws on the blank rear panel.
10. Reinstall the top cover and insert and tighten all top cover screws.
Module Removal