Tektronix HDVG1, Руководство по обслуживанию

Страница: 32 / 106

Installation
2- 8
HDVG1 HDTV Digital Video Generator Service Manual
10. Move the cursor to the signal’s field and place the cursor where you want the
test signal to be installed. Be sure to chose a destination that is one level
above the source. Press the Select key.
11. Touch Start Load . A pop-up menu tells you when the transfer is complete.
Signal and Logo Backup and Module Removal
Before removing a generator module, you should save the signal sets and logos
to a disk. The module will lose its signal memory 30 seconds after you remove it
from the platform. You will need a blank, DOS formatted 3.5 inch disk.
Save the signal sets as follows:
1. Insert a DOS formatted disk into the platform’s disk drive.
2. Push the Disk button and touch Save Signals to Disk .
3. Touch Select Source and select the HDVG1 . Use the cursor arrows to select
the HDVG1 module in the signals column.
4. Select Quit/Save .
5.
Touch
Select Destination
. If desired, create a new directory for the signals
by selecting New Dir and entering a DOS compatible name.
6. Create a new file by touching New File .
7. Select Quit/Save to complete the transfer of signal sets to the disk.
8. Touch Start Save . Saving signals may take several minutes, depending on
the number and size of test signals.
Save the logos as follows:
1. Push the Test Signals button.
2. Touch Module Parameters .
3.
Touch
Logo Overlay
.
4. Touch File Utils .
5.
Touch
Save Logo to Disk
.
6. Touch Select Source .
7.
Select the logo you want to save a disk file.
8. Touch Quit /Save .
Signal Backup
Logo Backup