Teknor Industrial Computers PCI-934, Техническое справочное руководство

Страница: 41 / 124

PCI-934 Technical Reference Manual
8-4
RS-422/RS-485 Mode
When configured for RS-422/RS-485 operation, the Serial Port 2 can transmit and
receive differential signals, in either full-duplex or party line communication.
Communicating with differential signals requires one pair of wires for the transmission
and a pair of wires for the reception (RS-422). For a better noise rejection, the use of
twisted pair cable is highly recommended. This will enable faster serial transmissions
over greater distances than with the common RS-232 protocol.
RS-422 - Full Duplex Operation : The RS-422 protocol uses both RX and TX lines
during a communication session. Upon power-up or reset, the Serial Port 2 interface
circuits are automatically configured for full duplex operation: pins 3 and 4 of J7 act as
the receiver lines and pins 5 and 6 act as the transmitter lines.
3
5
R X-
TX-
4
6
RX+
TX+
120 o hms
120 o hms
S ER IA L PO R T 2
10-P IN HE A D ER
RXD2
GND
VCC
TXD
X
X
1
1
2
2
LOW LO G IC LEV E L
LOW LO G IC LEV E L
7
7
6
6
3
3
4
4
In RS-422 mode, software should not use the handshake signals (e.g. DSR or DTR) since
they are not connected. However, software handshaking (e.g. XON-XOFF) can be used.