Teknor Industrial Computers PCI-934, Техническое справочное руководство

Страница: 114 / 124

BIOS Setup Error Codes
E-7
POST
(hex)
Name Description
0D Initialize Video Interface
& Chipset 1. On M1 set the cache for
the memory installed.
2. On PCI, do a PCI ROM
init.
3. On P6, Init. Apic.
4. Init. Chipset.
5. Turn ON CPU Cache.
6. Set Maximum Speed.
7. Measure CPU Clock
Speed.
8. Restore Speed.
9. Turn Off CPU Cache.
10. Early Video Shadow.
11. Read CMOS location 14h
to find out type of video to
use. Detect and initialize
Video Adapter.
12. Init. T380 if necessary.
Boot Block in EMERGENCY: Try
to init. Video Card…
0E Test Video Memory 1. If CGA or MONO, test video memory.
2. Beep the speaker.
3. Show the LOGO.
4. Install VT100 driver if necessary.
5. Write sign-on message to screen.
6. Write Copyright message to screen.
7. Write Evaluation message to screen.
8. Show CPU type and speed.
0F Test DMA Controller 0 Test DMA Controller 0.
10 Test DMA Controller 1 Test DMA Controller 1.
11 Test DMA Page Registers Test DMA Page Registers.
12 Reserved Reserved for 8254 Counter 0 - Not implemented.
13 Reserved Reserved for 8254 Counter 1 - Not implemented.
14 Test Timer Counter 2 Test 8254 Timer 0 Counter 2.
15 PIC Test 8259-1 mask bits Verify 8259 Channel 1 masked interrupts by alternately turning off
and on the interrupt lines.
16 PIC Test 8259-2 mask bits Verify 8259 Channel 1 masked interrupts by alternately turning off
and on the interrupt lines.
17 Test Struck 8259's Interrupt Bits Nothing
18 Test 8259 Interrupt functionality Force an interrupt and verify that the interrupt occurred (IRQ 0 -
clock int. 8h).
19 Test Struck NMI Bits (Parity/ IO
check) Nothing.
1A Reserved Reserved
: : :
: : :
1E Reserved Reserved
1F Set EISA Mode If EISA non-volatile memory checksum is good, execute EISA
initialization. If no, execute ISA test and clear EISA mode flag.
Test EISA Configuration Memory integrity (checksum &
communication interface).