Teknor Industrial Computers PCI-934, Техническое справочное руководство

Страница: 109 / 124

PCI-934 Technical Reference Manual
E-2
E.3 ERROR MESSAGES
One or more of the following messages may be displayed if the BIOS detects an error
during the POST.
CMOS BATTERY HAS FAILED
CMOS battery is no longer functional and should be replaced, or battery jumper is
removed and should be installed.
CMOS CHECKSUM ERROR
Checksum of CMOS is incorrect. This can indicate that CMOS has become corrupt.
This error may have been caused by a weak battery. Check the battery and replace it if
necessary. It can also happen if the battery jumper is removed: in such a case, it
should be installed.
DISK BOOT FAILURE, INSERT SYSTEM DISK AND PRESS ENTER
No boot device was found. This could mean either a boot drive was not detected or the
drive does not contain proper system boot files. Insert a system disk into Drive A and
press Enter. If you assumed the system would boot from the hard drive, make sure the
controller is inserted correctly and all cables are properly attached. Also be sure the
disk is formatted as a boot device. Then reboot the system.
DISKETTE DRIVES OR TYPES MISMATCH ERROR - RUN SETUP
Type of diskette drive installed in the system is different from CMOS definition. Run
Setup to reconfigure the drive type correctly.
DISPLAY TYPE HAS CHANGED SINCE LAST BOOT
Since last powering off the system, the display adapter has been changed. You must
configure the system for the new display type.
ERROR ENCOUNTERED INITIALIZING HARD DRIVE
Hard drive cannot be initialized. Be sure the adapter is installed correctly and all
cables are correctly and firmly attached. Also be sure the correct hard drive type is
selected in Setup.