Teka MB 620 BI, Руководство пользователя

Страница: 43 / 68

Before disposing of your appliance, render it
non-usable by pulling out the power cable, cutting this and disposing of it.
Use the “open” button to open the door and
remove all packaging materials. Then clean
the inside and the accessories with a damp
cloth and dry them. Do not use abrasive or
strong-smelling products.
Ensure that the following parts are in good
condition:

Door and hinges

Front of the microwave

Inner and outer surfaces of the appliance
DO NOT USE THE APPLIANCE if you notice
any kind of defect in the aforementioned
parts. If this occurs, contact the Technical
Support Service.
Place the appliance on a stable, flat surface.
Fit the rotating base in the centre of the
microwave cavity and place the rotating plate
on top until it clicks into position. Whenever
the microwave is used, both the rotating plate
and the respective base must be inside the
oven and correctly positioned. The rotating
plate turns clockwise and anti-clockwise.
Warning! The microwave oven may be
wrapped in a protective film. Before switching
it on for the first time, carefully remove this
film, starting at the underside.
In order to ensure proper ventilation for
the appliance, install the microwave in a
kitchen unit with an opening on the top
(see attached sheets).
Warning: after installing the microwave, it
is necessary to guarantee access to the
electrical socket.
During installation, ensure that the power
cable does not come into contact with the
back of the appliance, because the high
temperatures may damage the cable.
If you are installing a microwave and a
conventional oven in the same column,
the microwave must not be placed under
the oven, because of the formation of
condensation.
The appliance must not be placed in the
vicinity of heating elements, radios or
television sets.
The appliance is equipped with a power
cable and a plug for single phase current.
WARNING: The microwave MUST ONLY
BE
CONNECTED TO GROUNDED
ELECTRICAL SOCKETS.
In case of fault, the manufacturer and the
seller will not accept any responsibility if the
installation instructions have not been
properly followed.