The XT1 is shown here. Your actual model may vary.
10
• Your model’s Main Shaft may differ from what is shown in the
figures, however the assembly instructions remain the same.
• Facing the front of the A-Frame, hold the Main Shaft in your left
hand with the height markings facing up. Slide the end of the
Main Shaft into the Main Shaft Housing (Figure 15), located at the
base of the Table Bed.
• With your right hand, pull out the Height-Selector Locking Pin
(Figure 16) to allow the Main Shaft to slide in further and release
in the desired height setting. Refer to the Owner’s Manual for more
information on selecting your height setting.
• The Main Shaft MUST REST against the Crossbar bumper on the
A-Frame (Figure 17).
IMPORTANT:
The Crossbar prevents the Table Bed from rotating
forward when the user steps on the Ankle Comfort Dial. If the
Main Shaft does not rest on the Crossbar bumper as shown in
Figure 17, then the Table Bed has been assembled backwards
onto the A-Frame.
This
MUST BE CORRECTED
before use. See also Image B on Page 12
to ensure correct assembly.
• Test the inversion table by hand for smooth and steady rotation
(Figure 18) and ensure that all fasteners are secure.
STEP 5
Assemble Main Shaft to Table Bed
FIGURE 15
FIGURE 16
FIGURE 17
FIGURE 18