Tecomec GEOline 8410073, Инструкция и руководство пользователя

Страница: 39 / 68

ISOBUS ECU 1224 User and Instruction maual
|
P00801545 Rev:02 SW:1.0.0
38
To define any additional calibration point, the key shall be pressed, while if there are no
other points to be defined the key shall be pressed and the procedure ends confirming the
points so far acquired.
If the key is pressed at any time during the definition of the input calibration points, the
procedure is aborted (the calibration data contained in the non-volatile memory are not updated).
Tank level calibration settings are considered only if the “Tank level sensor present” parameter in
the SETUP page is checked.
If “Tank level sensor present” is not enabled , the tank level is calculated using the data from the
flow-meter sensor (quantity of sprayed product).
The access to the TANK CALIBRATION page is allowed only when no treatment is running (it is
assumed that a treatment is running when the main valve is open).
9.8 External warning lights LEDs
The ISOBUS ECU 1224 driver, is equipped with 5 green LEDs visible on the upper surface of the box
(the one indicated with L1, L2, L3, L4 and L5 in the following figure).
Figure 29
LEDs L4 and L5 are always turned on when the ISOBUS ECU 1224 is correctly powered .
LEDs L1, L2 and L3 display the ISOBUS ECU 1224 current status.