Tecnoalarm TP8-96, Руководство по установке, Страница: 83 / 118

TP8-96 VIDEO - Installer Manual Access configuration
5-7
PROGRAMMING OF THE ATTRIBUTES
To associate the attributes to the key check the relevant item.
z
By-pass
Enable the wireless key for the by-pass functions.
z
By-pass general alarms
If the function is enabled, the user will be entitled to arm the
system even in the presence of a general alarm (i.e. tamper,
low battery, power failure, supervision, trouble modules)
z
Automatic communicator block on disarming
If the function is enabled, upon disarming of the system with
wireless key, the active telephone channels and those
queued up are blocked automatically.
z
Confirmation of disarming (hold-up block)
Enables the wireless key for the hold-up function.
In this way, disarming with wireless key must be confirmed
by a valid user code within the programmed disarming
confirmation delay (Time parameters menu>confirmation of
disarming delay) in order to avoid the release of the hold-up
alarm. In fact, if disarming is not confirmed or confirmation
comes late, the control panel releases a silent alarm (i.e. no
acoustic signaling) and actives the programmed alarm call
cycles (transmission of the event>report codes>confirmation
of disarming)
z
Hold-up
If the function is enabled, it is possible to release a hold-up
alarm (panic) and activate the corresponding output by
pressing the keys 2 and 3 of the wireless key
simultaneously.
z
Zone exclusion disabled
If the function is enabled, the user will
not be entitled to arm
the control panel excluding some of the zones (both
voluntary and automatic zone exclusion are disabled).
The control panel will be armed in any case, and if there are
open zones, the alarm will be released.
Exclusion of the open zones with wireless key:
•
1 Press the program arming key. The console vocally
signals the presence of open zones.
• 2 Press again the program arming key. The console
vocally signals arming and the exclusion of the open
zones.
z
Siren impulse on arming
If the function is enabled, when the control panel is armed,
the siren is activated for a few seconds (1 pulse).
Repeat the procedure for all the wireless keys (1 to 100).
See § 5.4 for explanatory notes.
Press:
z
OK to confirm and quit
z
Abandon to quit without saving