Tecnoalarm TP8-96, Руководство по установке, Страница: 81 / 118

TP8-96 VIDEO - Installer Manual Access configuration
5-5
PROGRAMMING OF THE ATTRIBUTES
To associate the attributes to the key check the relevant item.
z
By-pass of general alarms
If the function is enabled, the user will be entitled to arm the system
even in the presence of a general alarm (i.e. tamper, low battery,
power failure, supervision, trouble modules)
z
Automatic communicator block on disarming
If the function is enabled, upon disarming of the system with
key/transponder/RFID card, the active telephone channels and those
queued up are blocked automatically.
z
Confirmation of disarming (hold-up block)
Activates the hold-up function on the key/transponder/RFID card.
In this way, disarming with these devices must be confirmed by a valid
user code before the programmed disarming confirmation delay
expires (Time parameters menu>confirmation of disarming delay) in
order to avoid the release of the hold-up alarm. In fact, if disarming is
not confirmed or confirmation comes late, the control panel releases a
silent alarm (i.e. no acoustic signaling) and actives the programmed
alarm call cycles (transmission of the event>report codes>confirmation
of disarming)
z
Zone exclusion disabled
If the function is enabled, the user will
not be entitled to arm the
control panel excluding some of the zones (both voluntary and
automatic zone exclusion are disabled).
The control panel will be armed in any case, and if there are open
zones, the alarm will be released.
If the item is checked, the zone exclusion is disabled.
Exclusion of open zones with key/transponder/RFID card:
•
1 Approach the device to the reader or insert the key.
The OCG LED blinks to signal the open zones.
Keep the device close to reader or the key into the activator.
• 2 Wait until the OCG LED turns off.
• 3 Move away the device from the reader or remove the key.
The program will be armed excluding the open zones.
z
Quick disarming
If the control panel is armed, on introduction of the electronic key into
the key reader or on approaching of the transponder or RFID card to
the reader, all the associated programs will be disarmed.
z
Learnt
Signals that the selected transponder/RFID card has been
programmed (learnt).
This function is not programmable. It is an indicator item.
If the item is checked, the device has been learnt.
Repeat the procedure for all the user codes (1 to 100).
See § 5.4 for explanatory notes.
Press:
z
OK to confirm and quit
z
Abandon to quit without saving