Tecnoalarm TP8-96, Руководство по установке, Страница: 103 / 118

TP8-96 VIDEO - Installer Manual Special procedures
A-3
A. SPECIAL PROCEDURES
A.1 RESET OF THE CODES
This procedure permits the deletion of all the access codes of the control panel and
setting of the default codes.
Warning: Before you reset the codes, always make sure that it is really
necessary and that the control panel is in stand-by (date and time displayed). If
need be, make a copy of the configuration of the control panel.
Here below the procedure for the reset of the access codes is explained.
z
Remove the jumper JP9
z
Insert the jumper JP3
z
The red, yellow and green LED of the electronic board are switched off
z
On the display of the console Line ! ABSENT ! is viewed and all the LED of the
console are blinking
z
When the firmware version of the console is viewed on the display of the console,
press the
EXIT key several times.
On the display is viewed Code Deleted .
z
Reinsert the jumper JP9
z
Remove the jumper JP3 and verify that the yellow LED is switched on.
After a few seconds, the control panel returns to stand-by and on the display
reappears date and time signaling.
Warning: On reset of the codes all of the system’s codes return to the default
setting. This is the same for the length codes:
z z z z z
Default installer code 54321
z z z z z
Default master code 12345
z z z z z
Default standard user codes 00000 (unvalid code)
z z z z z
Default code length 5 digits
(c) Tecnoalarm
Ver 0.7.05 ENG
Tue 12 JAN 10
Work. 10:45
Code
Deleted
Tue 12 JAN 10
Work. 10:45
Line
! ABSENT !