Instruction manual for receptor 868Mhz. 27
Subject to technical modifications without prior notice.
TP-20.1 u. 30.1-07/13
Programming the 1st channel to run the operator:
Adjustment for the antenna
as shown in the picture.
The maximum number of
channels that can be saved is 16.
1
Press the selected channel of the
hand-held transmitter. Red LED confirms
by flashing.
Wait about 10 seconds until
red LED turns off.
2
Press
TF
for approximately 5 seconds until red LED lights.
3
LED red
Press the selected channel
of the hand-held transmitter, (not the same
one as the 1st programmed channel).
Red LED confirms by flashing rapidly.
5
1.
1.
2.
2.
3.
4.
Press
TL
for approximately 5 seconds until red LED lights.
Press
TL
one more time briefly,
red LED blinks every 2 seconds.
6
To delete all programmed channels.
TS
TL
TF
TS
TL
TF
TS
TL
TF
Programming of the 2nd channel for light on/off.
4
1.
1.
2.
2.
3.
4.
The programming procedure terminates automatically after 10 secs. if no
other channel programming begins.
Press
TF
for approximately 5seconds until red LED lights.
Now press it again, briefly release, and press and hold
until red LED blinks rapidly. After release red LED will
blink every 5 seconds.
7
Checking of programmed functions.
1.
1.
2.
2.
3.
4.
TS
TL
TF
LED green
Press the selected channel of the
hand-held transmitter to confirm the function
of the garage door, LED green lights briefly.
Press the next selected channel of the
transmitter to confirm the function light
on/off, red LED lights briefly.
