Learning the end closing points of the door - Programming the power 25
1
Programming the travel path:
Press pushbutton
TL.
Remove 1 time for about 5 seconds until yellow LED lights.
TS
TL
2
To activate the travel path adjustment:
Press
TS.
Remove 1 time for about 1 second
until yellow LED begins to flash.
TS
TL
3
Programming in the end closing positions of the doors.
The
TS
button starts the door moving.
TS
TL
Attention:
Only set the end closing point of the door!
Chain or belt should never hang out from
the rail at the end closing point of the door.
Attention!
Shortly before the end closing point of the door is reached, adjust by pressing the button only very briefly
(1 press moves door approx. 2 mm).
4
Changing the direction of motion
Press the
TL
button for 1 sec. to change the direction
of motion.
TS
TL
The direction of motion can be changed as often as desired by briefly pressing the
TL
button.
This makes it possible to set the end closing point of the door exactly.
1 Sec
Press
TS
constantly until the end closing point of the
door is reached.
If you press TS briefly you can bring
the door slowly to the end closing point.
Yellow LED lights constantly.
Subject to technical modifications without prior notice.
TP-20.1 u. 30.1-07/13
