C
Copyright Technolog Ltd. 2017. All rights reserved.
Information contained in this document subject to
change without prior notice.
Sheet 36 of 41
Technolog Limited,
Ravenstor Road,
Wirksworth,
DE4 4FY,
United Kingdom
T: +44 (0) 1629 823611
E: [email protected]
www.technolog.com
DMR No.: 7311
2137PM9001 Rev. A
Supplementary - "Push data"
- Ensure the "Cello 6 Wizard" software has already been setup as per the "Installation:
Commissioning - Cello 6 Wizard: Startup" section of this manual for details.
- With the "Cello 6 Wizard" software displaying the "Welcome" page select "Push data".
- The software will now indicate all communication steps in the process of sending all the
stored data in the Cello 6S to the host computer.
- After the data has been sent, if there is no futher requirement to use the "Cello 6
Wizard" software with that particular Cello 6S, select "Exit" to terminate the software.
- Where further interrogation and / or setup of the particular Cello 6S is required, select
"Next". Refer to section the "Installation: Commissioning - Cello 6 Wizard: Signal
strength" section of this manual onwads for further details.
Installation: Commissioning
- Cello 6 Wizard: Supplementary - Push data
