C
Copyright Technolog Ltd. 2017. All rights reserved.
Information contained in this document subject to
change without prior notice.
Sheet 35 of 41
Technolog Limited,
Ravenstor Road,
Wirksworth,
DE4 4FY,
United Kingdom
T: +44 (0) 1629 823611
E: [email protected]
www.technolog.com
DMR No.: 7311
2137PM9001 Rev. A
Supplementary - "Diagnostic"
- Ensure the "Cello 6 Wizard" software has already been setup as per the "Installation:
Commissioning - Cello 6 Wizard: Startup" section of this manual for details.
- With the "Cello 6 Wizard" software displaying the "Welcome" page select "Diagnostic".
- The software now interrogates the Cello 6S and produces the following report where:
"IMEI" = Unique indentifier of the internal modem module.
"Telephone Number" = the 'phone number of the installed SIM card.
"Cello time" = the time and date of the Cello 6S when the report was
generated.
"FEP" = the version of firmare currently installed on the Cello 6S.
"Modem" = the version of firmware currently installed on the internal
modem module.
"Base Stations" = The details of the provider of the cellular network the
Cello 6S is currently using.
"Error log" = modem module entire logged along with their identifiers
"Wizard Comms Error Log" = local communications status.
- After the report has been generated, if there is no further requirement to use the "Cello
6 Wizard" software with that particular Cello 6S, select "Exit" to terminate the software.
- Where further interrogation and / or setup of the particular Cello 6S is required, select
"Next". Refer to section "Step 5 - Signal strength testing" of "Installation:
Commissioning" onwads for further details.
Installation: Commissioning
- Cello 6 Wizard: Supplementary - Diagnostic
