‘User Manual’’ Automatic Satellite Antennas TECHNO-MEDIA SRL
UMN_00094001
Rev 7
TECHNO-MEDIA SRL
Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - [email protected]
18
Installation of the BeepBox Version 2
The control and power supply box supplies
power to the antenna when you press the ON
button or when the vehicle is set in motion. It
allows you to close the antenna and to program
the type of decoder used.
Switching ON is delayed either pressing the ON
button or turning on the vehicle.
Install the Beep-Box leaving adequate ventilation to prevent electronics
failures.
Electrical Connections
After identifying the position and set the controller to the wall, proceed to connecting all the
wires of the same as shown below:
Plug the RJ45 connector from the antenna on
the roof of the vehicle in its connector, as shown
in figure until you hear the click of the retention
clips.
Take the SCART-SCART cable ** from the package
and connect the RCA connector to its connector on
the controller. Refer to the figure on the side
