‘User Manual’’ Automatic Satellite Antennas TECHNO-MEDIA SRL
UMN_00094001
Rev 7
TECHNO-MEDIA SRL
Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - [email protected]
16
Move the seal close to the connector
Screw the connector body as shown in the
figure. Perform the operation carefully avoiding
to turn the other party on the dome.
Do this by
hand without the use of tools, it is not
necessary to tighten too hard.
Screw the last part on the body of the
connector so that the gasket is contained
inside avoiding infiltrations of water.
Do
this by hand without the aid of tools, it
is not necessary to tighten too hard
Proceed at this point to the antenna cable
connection. Be careful not to rotate the
antenna connector on the body.
At this point the antenna installation will proceed in the vehicle. Had it not
been executed yet, be sure to fully sealed waterproof box or previously
mounted cable guide.
