‘User Manual’’ Automatic Satellite Antennas TECHNO-MEDIA SRL
UMN_00094001
Rev 7
TECHNO-MEDIA SRL
Via IV Novembre 92 20021 Bollate (MI) tel. 02/48672988 - [email protected]
27
Satellite Searching Process
The search of the pre-selected satellite is started as soon as the receiver is powered up
and the Antenna is powered up pressing the
ON
button.
•
When the receiver is powered UP a new searching process is started.
Scan Process
Here the different Scan steps:
1. The antenna move to the Zero position.
2. The antenna set the required inclination to pint the desired satellite using the
position provided by the GPS or the default elevation if the GPS does not have the
fix.
3. A complete rotation is performed.
4. Antenna move immediately back to the highest power satellite found.
5. A tuning process is started.
a) If a valid audio signal is revealed the Antenna stop in this position and will
be possible to close it only pressing the CLOSE button or switching on the
vehicle.
b) If the audio signal is not revealed, the system move to the next satellite.
If at the end of the loop no satellites are found, the scan is performed again with different
settings.
If at the end of all scanning processes the satellite is not found, the antenna will close
down.
