Call: 1-631-648-7481 or Visit: support.technocnc.com
3
HD Series Manual
NK105G2
www.technocnc.com
(HTT06081112)
Tel: 631-648-7481 • Email: [email protected]
All Techno machines are shipped assembled and secured to a wooden pallet.
Unpack all items that shipped
with your machine. Check the
items against the packing slip
to be sure nothing was left out.
Notify Techno immediately if
you are missing any pieces of
your shipment.
1.1
I. UNPACKING AND MACHINE IDENTIFICATIONS
Please note the 4 Forklift Tubes on
the front and rear of the machine.
II. MEASURING FORKS AND FORKLIFTING MACHINE
Front of Machine
Rear of Machine
1
2
4
3
Fig. 1.1
Care must be taken not to damage the
valves on the front of the machine.
Slowly move in close to the machine.
2.3
Fig. 2.3
Forklift your machine up from the
floor and remove the wooden pallet.
2.4
Fig. 2.4
Forks must be centered in the front
of the machine (shown in Fig 2.1).
2.1
Fig. 2.1
Measure the distance
between the forks.
(shown in Fig 2.2).
2.2
Fig. 2.2
For safety and to prevent damage to the machine
and cables, Lift Machine Using Forklift Tubes ONLY
If required, there are 4 Forklift Tubes
on the sides of the machine.
SAFETY WARNING: DO NOT LIFT OR MOVE MACHINE USING GANTRY
Depending on machine size — SEE QUOTE FOR MACHINE WEIGHT
NOTE: Forklift capacity must be adequate to safely lift the machine.
It is recommended to have Fork Lift Extensions to better support load.
FORKLIFT GUIDE