6
Call: 1-631-648-7481 or Visit: support.technocnc.com
HD Series Manual
NK105G2
Carefully remove the HD Mini from its crate. Be
sure to remove the brackets from its four feet
as well as anything stowed under the HD mini
during shipping.
Attached the provided leveling feet to the four
legs and adjust accordingly until the table is level.
Remove the front panel of the HD Mini using a
M4 allen wrench to install the handheld controller
to the machine.
Attached the handheld to the controller (Fig. 1.1)
and replace the front panel, carefully routing the
handheld wire through the access port.
1.2
I. TECHNO HD MINI SETUP
The power cable is supplied without a plug.
You will need to supply your own plug.
Plug the power cable into the rear of the machine as shown
in figure 1.2
Have a suitably qualified person attach the correct plug
in compliance with the wiring standards in your area.
The machine must be connected to a 220V, single phase,
15A circuit.
The cable that we supply will be one of two types.
It may either be a cable with a brown, blue, and green/
yellow wire or a cable with a black, white, and green wire.
(Fig 1.3)
Power is connected as follows:
Green or Green/Yellow conductor is always ground .
The two other conductors will be the hot leads.
Fig. 1.3
Fig. 1.1
Fig. 1.2
