4
Call: 1-631-648-7481 or Visit: support.technocnc.com
HD Series Manual
NK105G2
1.
Keep fingers, hands, and all other objects away
from machine while power is on.
2.
Disconnect power to all system components
when not in use, when changing accessories, and
before servicing.
3.
Do not loosen, remove, or adjust machine parts or
cables while power is on.
4.
Exercise care with machine controls and around
keyboard to avoid unintentional starting.
5.
Make sure voltage supplied is appropriate to
specifications of components.
6.
Machines must be plugged into three-pronged
grounded outlets. Do not remove the grounding
plug or connect into an ungrounded extension
cord.
7.
Keep cables and cords away from heat, oil, and
sharp edges. Do not overstretch or run them
under other objects or over work surfaces.
8.
Use proper fixtures and clamps to secure work.
Never use hands to secure work.
9.
Do not attempt to exceed limits of machine.
10. Do not attempt to use machine for purposes other
than what is intended.
11. Use machine only in clean, well-lit areas free from
flammable liquids and excessive moisture.
12. Stay alert at all times when operating the
machine.
13. Always wear safety goggles.
14. Do not wear loose-fitting clothing when operating
machine. Long hair should be protected.
15. Always maintain proper balance and footing
when working around the machine.
16. Maintain equipment with care. Keep cutting
tools clean and sharp. Lubricate and change
accessories when necessary. Cables and cords
should be inspected regularly. Keep controls
clean and dry.
17. Before using, check for damaged parts. An
authorized service center should perform all
repairs. Only identical or authorized replacement
parts should be used.
18. Remove any adjusting keys and wrenches before
turning machine on.
19. Do not operate the machine unattended.
20. Follow all safety instructions and processing
instructions in the MSDS for the material being
processed.
21. Use proper precautions with dust collection
systems to prevent sparks and fire hazards.
22. Make sure to have proper fire extinguishing
equipment on hand at all times.
WARNING:
IMPROPER OR UNSAFE OPERATION OF THE MACHINE WILL RESULT IN
PERSONAL INJURY AND/OR DAMAGE TO THE EQUIPMENT.
READ THESE INSTRUCTIONS THOROUGHLY BEFORE OPERATING MACHINE. DO NOT
OPERATE MACHINE IF YOU ARE UNFAMILIAR WITH THESE SAFE OPERATING INSTRUCTIONS.
DO NOT OPERATE MACHINE WITHOUT KNOWING WHERE THE EMERGENCY STOP SWITCH
IS LOCATED.
PREVENT FIRE HAZARDS by using the proper feeds, speeds, and tooling while operating your
Techno machine. For example, setting feeds and speeds too low and/or using dull tool bits creates
friction at the material. The friction generates heat which can result in a fire that can be drawn
through the vacuum table or dust collector without warning. Fire hazard from friction heating
caused by dull tools is possible when cutting certain materials, especially composite material such
as wood composites, MDF and Particleboard.
© 2012
Safety Instructions