Team Losi XXX-NT AD2, Руководство пользователя

Страница: 10 / 65

42
8
38
11
54
B B
B B
BA A
A A
AG B (Contin G B (Contin
G B (Contin G B (Contin
G B (Continued) ued)
ued) ued)
ued)
7
Step B-11
*NOTE: Assure that the grooves on all of the front Turnbuckles are located on the drivers right-hand side for easier adjustment later.
‰
1. Snap one end of a steering Tierod assembly (Figure B-10B) to the Ball Stud (11) in the steering Servo Saver Bottom (8). Snap the other
end to the Ball Stud (38) in the left Spindle (42).
‰
2. Attach the second steering Tierod to the right side of the car.
Steering Tierod Install:
Step B-10
There is a small container/package of White Grease
(71) in this bag. It is recommened that a small amount of this be
applied to the threads of the Turnbuckles before trying to thread on
the plastic Rod Ends. Please use this lube sparingly as it will be used
during the assembly of the Differential as well.
*NOTE: The two ends of the Turnbuckle are threaded opposite.
The end closest to the groove, next to the square, has standard right-
hand threads, the other end has left-hand threads. This allows the
length of the Tierods, once installed, to be adjusted without remov-
ing them.
‰
1.Thread a Plastic Rod End (54) onto each End of a 2-3/8" Turn-
buckle (55). Tighten both Rod Ends equally until the Rod is the same
length and the Rod Ends are in the same orientation as the assembled
Tierod in Figure B-10B. Make two of these Tierod assemblies.
Figure B-10A
Figure B-10B
Steering Tierod:
Figure B-11
55
54
71
54
55