409-32034
Rev D
5 of 31
ORIGINAL APPLICATOR
FEED TYPE
CHANGEOVER CAMS FOR THE MACHINES
1 5/8-in. [41.25 mm]
Stroke Machines
1 1/8-in. [30 mm]
Stroke Machines
1 1/8-in. Stroke Applicator for
Model “K" Terminating Machine
Pre-Feed
690602-6
---
Post-Feed
690501-4
---
1 5/8-in. Stroke Applicator for
Model “T" and Model “G"
Terminating Machines
Pre-Feed
---
690602-5
Post-Feed
---
690501-3
Heavy-Duty Industrial (HD-I)
Applicator
Pre-Feed/Post-Feed
Refer to the HD-I Applicator customer drawing for part numbers.
Figure 2
2.1.
Functional Description
These machines provide the force required to crimp terminals in the applicator. A terminal is attached to the
wire by placing the wire in the crimp area and pressing the footswitch. The machine consists of four functional
areas:
1. The
motor group
includes a dc motor which drives a crankshaft. The motor is activated each cycle
and rotates the crankshaft one full revolution. A 6 mm hex key placed in the recess located on the end
of the motor, can be used to cycle the motor manually. See Figure 3.
2. The
crankshaft-ram group
converts the motor’s rotational motion into the up
-and-down action of the
ram for driving the applicator during the crimping cycle.
Figure 3
Crankshaft
DC Motor
Hex Key
Location for
Manual
Cycling
Power Cord
Receptacle
