409-32034
Rev D
27 of 31
Figure 18
8.3.
Installation of Batch Counter Kit 1424267-1
DANGER
To avoid personal injury, be sure to turn "off" the machine, and disconnect it from the power source.
1. Open the clear guard on the machine to gain access to the two socket head screws securing the user
interface to the frame.
2. Remove the two socket head cap screws securing the user interface to the frame. Carefully lift the
user interface assembly to clear the sheet metal guard.
CAUTION
Use caution when removing the interface so that the wiring harness to the interface is not damaged.
3. Disconnect the wiring harness connector from the pc board inside the user interface assembly.
4. Remove the batch counter kit knockout from the front of the user interface assembly.
CAUTION
Do not damage the pc board inside the interface assembly when removing knockout.
5. Insert the connector end of the batch counter wire through the knockout opening.
6. Plug the batch counter connector into the J2 connector on the user interface assembly pc board. See
Figure 19.
7. Insert the batch counter kit into the knockout opening until it snaps into place. The red reset button
should be on the right-hand side.
8. Attach the connector from the machine wiring harness to the J1 connector on the user interface
assembly pc board.
