409-32034
Rev D
19 of 31
Figure 11
7.
ADJUSTMENTS
The following adjustments are necessary to maintain the machine in operating condition, and to set up the
machine after replacing parts.
DANGER
To avoid personal injury, ALWAYS disconnect electrical and air supplies before performing adjustments.
7.1.
Measuring the Shut Height
The shut height is the distance between the bottom surface of the ram post adaptor and the top surface of the
machine base plate as shown in Figure 12.
NOTE
Shut Height Gage 679655-[ ] (see the table in Figure 12) is recommended for measuring the shut height (refer to 408-8535 for
instructions on use of the gage).
1.
If installed, adjust the manual precision adjustment lever to the “0” crimp setting.
2. Turn off the machine and disconnect the power cord plugged into the receptacle mounted to the motor
end plate (Figure 6).
3. Insert a 6-mm hex wrench into the end of the motor until it completely engages the recess in the end
of the motor. Use the hex wrench to manually rotate the motor.
DANGER
Be sure to remove the hex wrench before operating the machine.
4. Follow the procedure for measuring the shut height as described in 408-8535.
5. Remove the hex wrench when finished and plug in the power cord.
Lubrication Points
Precision Crimp
Height Adjustment
Mechanism
Lubrication
Points
