TE AMP 3K/40, Руководство пользователя

Страница: 12 / 23

409-10204
Rev G
12 of 23
Figure 9
4. Set the crimp height and insulation crimp discs so that the letters and numbers on the applicator pad
align with the front pad on the ram post adapter.
5. If the applicator is an air-feed type, make sure the front door cover is closed, then connect the airlines
to the valves located on the back of the machine.
NOTE
Quick Disconnect Coupling PN 23238-1 is required to run air-feed applicators.
6. Adjust the reel support for side-feed or end-feed product, depending on the applicator being used.
7. Mount the terminal strip guide on the left sheet metal guard for side-feed product, or on the right sheet
metal guard for end-feed product, depending on the applicator being used.
8. Mount the terminal reel on the reel support. Thread the terminal strip through the guard and into the
applicator according to the instruction sheet included with the applicator. If necessary, adjust the
lubricator bowl.
9. Align the product reel to the applicator by adjusting the reel flanges.
10. Close the guard.
NOTE
The guard door must be closed in order to operate the machine. See paragraph 4.4.C.
Speed Indication
Guard Status
Machine Status/
Error Code
Error Reset
Batch Count
Count Reset
Speed
Decrease
Jog
Speed
Increase
Main Power Switch
Decrease Speed -- Decrease the motor speed for normal cycle operation and for jogging.
Increase Speed -- Increase the motor speed for normal cycle operation and for jogging.
Error Reset -- Clears the displayed error code.
Count Reset -- Clears the batch count to 0.
Jog -- Causes the DC motor to rotate at the jog speed set by the Increase / Decrease Speed.
Speed Indication - - Each
“>”
represents a portion of the full operation or jog speed setting. Minimum speed is denoted
with a single
“
>. Maximum speed is denoted by
“>>
>>
>>.”
Machine Status / Error Code Display -- Displays
“O
K
”
if there is no error code being displayed or
“ERRxxx”
when an
error has occurred. The
“xxx”
represents a number corresponding to an error described in the error code table (Figure 17).
Guard Status Indication -- A solid
“ 
" indicates that the guard interlock is closed. An open icon in this display indicates
that the guard interlock is open. The DC motor will not run when the guard interlock is open.