TDK-Lambda Z160-1.3, Руководство пользователя

Страница: 34 / 140

39
1 (-) sense
2 Local (-) Sense
3 Not Connected
4 Local (+) sense
5 (+) sense
Fig.3-3: Sense connector default connection
Plug P/N: 43645-0500
(MOLEX)
2. Ensure that the protection of output plug is mounted and properly assembled.
3. Connect the unit to an AC source as described in section 3.7.
4. Connect a DVM with appropriate cables for the rated voltage to the output terminals.
5. Turn the front panel AC power switch to On.
6. When power supply is turned ON the display shows ”

” and all LEDs illuminate momentarily.
The power supply operating status is then displayed.
3.7.2 AC Input Cord
Refer to section 1.3.4 for details of the AC input cords recommended.
WARNING:
The AC input cord plug is the disconnect device of the power supply. The plug must be readily
identifiable and accessible to the user. The AC input cord must be no longer than 3m.
WARNUNG:
Die Stromversorgung wird durch Ziehen des Netzkabels vom Versorgungsnetz getrennt. Der Stecker
muss fur den Benutzer leicht erkennbar und jederzeit zuganglich sein. Das Netzkabel darf nicht
langer als drei Meter sein.
3.8 Turn-On Checkout Procedure
3.8.1 General
The following procedure ensures that the power supply is operational and may be used as a basic
incoming inspection check.
3.8.2 Prior to Operation
1. Ensure that the power supply is configured to the default setting:
AC On/Off switch at Off position.
Sense connector : Configured to Local Sense as shown in Fig.3-3: