TDK-Lambda Z160-1.3, Руководство пользователя

Страница: 121 / 140

126
NOTE:
For an easy way to create arbitrary waveforms, you can use the ”Z
+
Waveform Creator” Application
that can be installed from the CD-ROM shipped with the product. (for further information, see the
‘Quick Start Guide’ on the CD-ROM).
8.6.3 Wave Execution via Front Panel
1. Load stored data MENU -> ” ROG ” -> ” OAD ” -> 2
2. Set Trigger IN source ( BUS for Command or Front Panel and EXT via Rear Panel J3.2 pin)
MENU -> ” TRiG ” -> ” TR. In ” -> ” BS ”
3. Set Trigger Initialize Continue mode (If 1 then after program execution power supply will be
ready for the next trigger. If 0 then send INIT command MENU -> ” TriG ” -> ” ConT ” -> ” EnA ” to
get to the next trigger.
4. Set INIT command. (Power supply ready for TRIGGER) MENU -> ”
TRiG
” -> ”
iniT
” -> ”
iniT
”
5. Exit from MENU and Press Current encoder to trigger.
8.7 Additional Examples
8.7.1 List Example
TRIG:SOUR BUS Select trigger source external analog signal
0
2
4
6
8
10
0 1 2 3 4 5
Times [S]
Voltage [V]
VOLT:MODE LIST Select sequence mode ”LIST”
LIST:VOLT 2,4,2,8,5,4 Set voltage values ”2,4,2,8,5,4” Volts
LIST:DWEL 0.5,0.5,1,1,1,1 Set dwell values ”0.5,0.5,1,1,1,1” seconds
LIST:COUN 1 Set list execution time ”1”
LIST:STEP AUTO Set step execution mode ”AUTO”
INIT:CONT OFF Trigger subsystem enabled for a single
trigger action
INIT Trigger initializing
*TRG Trigger command
8.7.2 Waveform Example
TRIG:SOUR BUS Select trigger source via communication
interface or front panel
0
2
4
6
8
10
0 1 2 3 4 5 6
Times [S]
Voltage [V]
VOLT:MODE WAVE Select sequence mode ”WAVE”
WAVE:VOLT 2,2,4,4,9,9,3,3 Set voltage values ”2,2,4,4,9,9,3,3” Volts
WAVE:TIME 0,1,0.5,0.5,0.5,0.5,1.5,1 Set time values ”0,1,0.5,0.5,0.5,0.5,1.5,1” seconds
WAVE:COUN 2
Set wave execution time ”2”
WAVE:STEP AUTO Set step execution mode ”AUTO”
INIT:CONT ON Trigger system is continuously enabled
INIT Trigger initializing
*TRG Trigger command