TDK-Lambda Z160-1.3, Руководство пользователя

Страница: 111 / 140

116
WAVE:STEP
•
WAVE:STEP AUTO - When triggered, creates waveforms consecutively, until the wave is completed.
•
WAVE:STEP ONCE - When triggered, it executes one step from the list.
SCPI Command Syntax [SOURce]WAVE:STEP <CRD>
Example WAVE:STEP AUTO
Query Syntax [SOURce]:WAVE:STEP?
Returned Parameters AUTO | ONCE
WAVE:STORe
Stores Voltage or Current, Time, STEP parameter and counter values to specific location in the
memory defined by numbers <1..4>.
SCPI Command Syntax [SOURce]WAVE:STORe<NF1>
Example WAVE:STORe 3
WAVE:TIME
Sets the slope time of the waveform.
SCPI Command Syntax [SOURce]:WAVE:TIME <NRf1> {,<NRf1>}
Range 0.01 to 129,600 seconds
Default Suffix S
Examples WAVE:TIME .6,1.5,1.5,.4 up to 12 parameters
Query Syntax WAVE:TIME?
Returned Parameters .6,1.5,1.5,.4
WAVE:VOLTage
Specifies the output voltage points in a waveform list.
SCPI Command Syntax [SOURce]:WAVE:VOLTage <NRf+> {,<NRf+>}
Default Suffix V
Examples WAVE:VOLT 2.5,3.0,3.5 WAVE:VOLT MAX,2.5,MIN up to 12 parameters
Query Syntax WAVE:VOLT?
Returned Parameters MAX,2.5,MIN
7.12.13 Global Subsystem
Global Commands General
•
Power supplies acting upon Global Commands need not be a currently addressed supply.
•
All power supplies attached to the Interface must be capable of accepting Global Commands.
•
No messages, OPC or Not Busy will be returned to the HOST PC after a Global Command has
been issued. The Busy Bit of the Status Byte will be set to 0 after this command is issued.
•
It will be the responsibility of the User Software to add a 20mS delay after each Global Command
is issued and before any other command can be issued.